Dis-Assembly

From Cricut Hacking Wiki
Revision as of 21:37, 30 January 2014 by Cricutwikiadmin (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Dis-Assembly Tips

Problem

Accessing the Motherboard for troubleshooting purposes

Solution

Roll the machine on to it's back and use a #1 Phillips Screwdriver (+) to remove the approx. 8 screws that are exposed. The bottom of the machine should come off easily at this point and by carefully tugging the wires that connect the upper and lower sections it should be possible to keep the main unit on it's back and review the exposed motherboard.

Problem

Removing the Side covers should be avoided if possible, it is difficult to not scratch them in the process.

Solution

If you must remove the Side covers consider using a putty knife or similar to carefully pry the trim piece off. Once it's removed there are 5 to 6 screws that will remove the cover itself.

Note: The trim pieces are not required for the Cricut to function, so you can choose if they are re-installed or disposed of.

References

everhack blog atxhackerspace